Section02717ENGINE
Subsection 03 (TOP END)
F00B0OA
21
TYPICAL
1. Piston pin
2. Shoulder sleeve
– Insert extractor spindle into the piston pin,
screw on extracting nut.
F00B0PA
12
TYPICAL
1. Puller installed on the opposite side of the piston pin
2. Tighten extracting nut
– Rotate handle to pull piston pin carefully into the
piston.
Plastic Mounting Device Method
This is an alternate method when no service tool
is available.
Replacement roller bearings are delivered in a con-
venient plastic mounting device. For installation,
proceed as follows:
– Align replacement roller bearing with connect-
ing rod bore.
– Carefully push inner plastic sleeve into con-
necting rod bore; outer plastic ring will release
rollers.
F01D0QA
1
1. Outer ring removal after inner sleeve insertion into bore
– Make sure thrust washers no. 12 are present
each side of rollers.
F01D0VA
1
1. Thrust washer each side
– Insert piston pin no. 10 into piston no. 8 until it
comes flush with inward edge of piston hub.
smr2005-077 31
To Next Page
Loading...
Need help?
General
