51
GGEEAARRCCAASSEE VVEENNTT
1. Vent plug
4. Place a container under the drain.
EENNVVIIRROONNMMEENNTTAALL NNOOTTEE
Dispose of used oil or oil contami-
nated shop towels in an environmen-
tally responsible manner, or
according to local regulations.
5. Open the gearcase drain plug.
GGEEAARRCCAASSEE DDRRAAIINN
1. Drain plug
IIMMPPOORRTTAANNTT: The recommended
gear lubricant is formulated for marine
applications. Do not use automotive
gear lubricants, engine oils, or any
other oil or grease.
6. Use Gearcase Filler, P/N 501882,
to slowly fill the gearcase with
HPF
Pro
lubricant until lubricant exits
the gearcase vent.
IIMMPPOORRTTAANNTT: Filling the gear-
case too quickly can cause air pockets
and the gearcase may not fill
completely.
7. Wait 5 minutes for the oil to settle.
8. Continue filling again until oil exits
the vent. For recommended gear-
case lubricant capacity, refer to
TECHNICAL SPECIFICATIONS
.
9. Clean vent seal area and install
the gearcase vent plug and a nneeww
seal. Tighten the plug to a torque
of 60 to 84 in. lbs. (7 to 9.5 N·m).
10.Clean drain seal area and install
the lubricant drain/fill plug and a
nneeww seal. Tighten the plug to a tor-
que of 60 to 84 in. lbs. (7 to 9.5
N·m).
PPrrooppeelllleerr
PPrrooppeelllleerr RReemmoovvaall
WWAARRNNIINNGG
WWhheenn sseerrvviicciinngg tthhee pprrooppeelllleerr,, aall--
wwaayyss sshhiifftt tthhee oouuttbbooaarrdd ttoo tthhee
NNEEUUTTRRAALL ppoossiittiioonn,, ttuurrnn tthhee kkeeyy
sswwiittcchh OOFFFF,, aanndd rreemmoovvee tthhee kkeeyy
ssoo tthhee oouuttbbooaarrdd ccaannnnoott bbee ssttaarrtteedd
aacccciiddeennttaallllyy..
1. Remove the cotter pin from the
propeller shaft. Discard the cotter
pin.
1. Cotter pin
MAINTENANCE PROCEDURES
To Next Page
Loading...
Need help?
General