53
N·m), and then remove the block
of wood.
7. Install a new cotter pin.
1. Cotter pin
IIMMPPOORRTTAANNTT: After installation,
make sure outboard is in NEUTRAL
and carefully spin the propeller. The
propeller must turn freely without bind-
ing and should not spin off center. If
the propeller binds, check for the cor-
rect propeller thrust washer, P/N
128805. If propeller appears to wob-
ble, check for possible bent propeller
shaft.
BBaatttteerryy
BBaatttteerryy MMaaiinntteennaannccee
When storing the boat, the battery
should always be stored in a warm,
dry place.
WWAARRNNIINNGG
NNeevveerr cchhaarrggee oorr bboooosstt tthhee bbaatttteerryy
wwhhiillee iinnssttaalllleedd iinn tthhee bbooaatt..
For information about the recom-
mended battery type for your engine,
refer to
Technical Specifications
.
RReemmoovviinngg tthhee BBaatttteerryy
1. Disconnect BLACK (-) cable first,
then RED (+) cable.
NNOOTTIICCEE
AAllwwaayyss ddiissccoonnnneecctt tthhee BBLLAACCKK ((--))
ccaabbllee ffiirrsstt,, tthheenn tthhee RREEDD ((++))
ccaabbllee..
2. Remove the battery hold down tray
or tie down.
3. Remove battery.
CChhaarrggiinngg tthhee BBaatttteerryy
Use any automotive type battery
charger. Always refer to the battery
charger manufacturer’s instructions.
CClleeaanniinngg tthhee BBaatttteerryy
Clean battery casing and battery
posts using a soft brush and a solution
of baking soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush.
Rinse with clear water then dry well.
IInnssttaalllliinngg tthhee BBaatttteerryy
1. Connect the battery cables.
NNOOTTEE:: Remove any water or debris
if present in the compartment before
installing the battery.
NNOOTTIICCEE
AAllwwaayyss ccoonnnneecctt tthhee RREEDD ((++)) ccaabbllee
ffiirrsstt,, tthheenn tthhee BBLLAACCKK ((--)) ccaabbllee..
2. Tighten the battery cable nuts to
specification.
TTiigghhtteenniinngg TToorrqquuee
Battery
cable nut
4 ± 0.5 Nm
(35 ± 4 lbf-in)
3. Apply dielectric grease on battery
posts.
4. Cover positive battery post with
rubber boot.
MAINTENANCE PROCEDURES