55
the powerhead to drain
completely.
8. Remove the garden hose from the
flushing port.
9. Install the cap onto the flushing
port.
10.Close the access hatch cover.
11.Reinstall propeller.
FFlluusshhiinngg —— OOuuttbbooaarrdd NNoott RRuunnnniinngg
1. Open the appropriate access
hatch cover (location may differs
depending on the boat model).
2. Place outboard in VERTICAL
(DOWN) position.
3. Remove the cap from the flushing
port.
4. Thread the garden hose onto the
flushing port.
5. Turn water supply on.
6. Flush outboard for at least five
minutes.
7. Turn off water supply.
8. Leave the outboard in VERTICAL
(DOWN) position long enough for
the powerhead to drain
completely.
9. Remove the garden hose from the
flushing port.
10.Install the cap onto the flushing
port.
11.Close the access hatch cover.
MAINTENANCE PROCEDURES
To Next Page
Loading...