Roth MINI - Installation

5
TECHNICAL DATA
Roth Power Supply series
* Step 1: 300 V / 16 mA / 30 min
Step 2: 300 V / 24 mA / 240 min
If voltage, current and time set 0 in step 2, system will not proceed to step 2.
INSTALLATION
ROTH power supply MINI is actually a pre-installed instrument. As long as it is placed on a sturdy and
level surface in a safe, dry place, and further connects with well-prepared electrophoresis system, it is
ready for operation.
Type
MINI
STANDARD
BLOT
Model
nanoPAC-300P
PowerPro300
PowerPro3AMP
Voltage (V)
10-300
5-300
5-300
Max. intensity of current
1-400 mA
1-700 mA
10-3000 mA
Max. output power
60 W
150 W
300 W
Timer
1-999 min.
1-999 min.
1-999 min.
Volt-hours
49,995 kVh
Display
LED
2,4“ TFT
2,4“ TFT
Resolution
1 V, 1 mA
1 V, 1 mA
1 V, 10 mA, 1 W
Type of output
Constant V or mA with automatic crossover
-
During constant mode not adjusted parameters are
automatically set to maximum
Programs
Manuell adjustable mode (Constant Mode)
2-step program
editable
30 programs, each with up to 6 steps editable (Program
Mode)
2-step program, pre-
assigned*
Pre-assigned programs for different applications (Typical
running condition Mode)
Outlets (parallel socket
pairs)
2 (4 mm)
5 (4 mm)
5 (4 mm)
Min. load resistor
5 Ω
3 Ω
0,1 Ω
Safety detections
No load
Over load
Over temperature
No load
Over load
Leakage
No load
Over load
Leakage
Protection
-
Over temperature
Over temperature
Automatic recovery after
power failure
-
Yes
Yes
IQ/OQ Protocols
-
Yes, optional
Yes, optional
Ambient temperature
4-40 °C
4-40 °C
4-40 °C
Regulatory
CE, ETL, FCC
CE, ETL
CE
Dimensions (cm)
14 x 19,1 x 8,4
21,5 x 33,5 x 10,4
21,5 x 33,5 x 10,4
Weight
1,0 kg
2,1 kg
2,1 kg
Rated Voltages
100-240 V, 50-60 Hz,
2,5 A
100-240 V, 47-60 Hz,
200 W
100-240 V, 47-60 Hz,
410 W