Roth Touchline SL Series User Manual

1/8
Living full of energy
Roth Touchline® SL rumtermostat X
Roth Touchline® SL termostat X
Roth Touchline® SL termostat X
Roth Touchline® SL huonetermostaatti X
Roth Touchline® SL room thermostat X
Roth Touchline® SL
Installation
Installation Roth Touchline® SL room thermostat_X_20231129

Roth Touchline SL Series Specifications

General

Display	LCD
Control	Touchscreen
Connectivity	Wired
Power Supply	230V AC
Mounting	Wall-mounted
Switching Current	16A
Frost Protection	Yes
Floor Sensor	Optional
Accuracy	±0.5°C
Weight	150 g
Protection Rating	IP20
Temperature Range	5°C to 35°C
Dimensions	86 x 86 x 45mm

Summary

Thermostat Unit Setup and Mounting

Separating Thermostat Body and Installing Batteries

Detach the thermostat body from the backplate and insert batteries, observing polarity.

Connecting Floor Sensor and Mounting Backplate

Connect the optional floor sensor and mount the backplate onto the wall.

Pairing Thermostat with Controller

Registering Thermostat to a Zone

Follow controller steps to pair the thermostat to a specific zone or channel.

Confirming Registration and Display Overview

Understand the controller display after successful thermostat registration.

Floor Sensor Configuration

Registering the Floor Sensor

Pair the connected floor sensor with the controller.

Setting Floor Sensor Operation Modes

Configure the floor sensor mode to 'Floor protection' or 'Comfort'.

Setting Floor Temperature Limits

Set maximum floor temperature for protection and minimum for comfort.

Thermostat Interface and Settings

Displaying Current Temperature

View current temperature and adjust settings using < > buttons.

Switching Display Modes

Toggle between temperature and relative humidity display.

Operating Modes and Battery Check

Select operating modes (Con, 5h, OFF) and check battery level.

Locking and Resetting Thermostat

Lock control buttons or reset thermostat to factory settings.