ROTOTILT ICS Direct Translation Of The Original Instruction

13 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

2019-08-19

_7733

2200399

Control System - ICS Direct

Track Control

Translation of the Original Instructions _EN

Table of Contents

Other manuals for ROTOTILT ICS Direct

Questions and Answers:

D
Denise NealAug 16, 2025
How to fix 'Calibration' error on ROTOTILT ICS Direct Control Systems?
- M
  Melissa TuckerAug 16, 2025
  If your ROTOTILT Control Systems displays a 'Calibration' error, it indicates that either the left or right roller wasn't properly calibrated. This means the control system has cleared the roller's calibration, stopping output signals. This can be caused by cable breakage, connector play, or a roller fault. To resolve this, calibrate the roller by pulling it to each end position for at least 3 seconds. If that doesn't work, replace the roller and calibrate it as described.
A
Andrew RussellAug 19, 2025
What to do if supply to roller right is broken in ROTOTILT Control Systems?
- M
  Ms. Julie FritzAug 20, 2025
  If the supply to the roller right is broken, which may be caused by an open or short circuit on the harness, you should first check the harness to the joystick for any crush damage or open circuits. You can also try restarting the system. If the issue persists, further assistance may be needed.

ROTOTILT ICS Direct Specifications

General

Brand	ROTOTILT
Model	ICS Direct
Category	Control Systems
Language	English

Related product manuals

Preview: ROTOTILT ICS