Note: Rottler reserves the rights to change any specifications
and over all product design out any notice.
SGF8 Specifications
DRIVE SYSTEM Double reduction two poly "V" belt
MOTOR Motor-180 volt DC 1 HP Baldor
Input voltage; 220V-single phase 50 / 60 Hz
SPINDLE ROTATION
SPEED
Variable and reversible from 0 - 400 RPM
SPINDLE TRAVEL 8"
SPINDLE DIAMETER 3.150"
TAPER IN SPINDLE Rottler Special ISO - 30
SPINDLE TILT 15
o
± .01
o
in both directions for a total of 30
o
SPINDLE TO TABLE
CLEARANCE
16 ¼”
MAXIMUM WORK PIECE
HEIGHT A
15” with Toolholder over the pilot
13” with Toolholder on the spindle
MAXIMUM CYLINDER
HEAD LENGTH ON 360º
ROLLOVER FIXTURE C
43” on out side locking handles
48" on inside locking handles
(unlimited without fixture)
OVERALL LENGTH ON
UPPER SURFACES
53”
OVERALL HEIGHT 83"
AIR REQUIREMENT 100 P.S.I.
FLOOR SPACE
REQUIREMENTS
33" deep x 93" wide
with tool box and sharpener
SHIPPING WEIGHT 2600 lbs. machine only
To Next Page
Loading...
