Roughneck 57133 - User Manual

Questions and Answers

T
Tiffany HansenAug 11, 2025
How to fix a Roughneck 57133 when the motor is not turning?
- L
  Lori JohnsonAug 11, 2025
  If the motor of your Roughneck Water Pump is not turning, consider the following: * **Lack of electric power:** Check the electrical connections and the safety systems. * **Rotor jams:** Check for possible damage or obstruction of the rotating components. * **Thermal overload protection shut:** Move the ON/OFF lever to the “OFF” position to reset the pump. * **Motor problems:** Contact with the service department.
F
fitzgeraldwendyAug 20, 2025
Why is my Roughneck 57133 making increased noise?
- A
  Alex MedinaAug 20, 2025
  Increased noise in your Roughneck Water Pump can be due to: * **Cavitations occurring:** Reduce suction pressure. * **Irregular functioning of the by-pass:** Dispense until the air is purged from the circuit. * **Air present in the diesel fuel:** Verify the suction connections.
J
jenniferyorkAug 27, 2025
What causes leakage from the Roughneck 57133 Water Pump body?
- R
  Randy PerezAug 27, 2025
  Leakage from the Roughneck Water Pump body is often caused by a damaged seal. Check and replace the mechanical seal.
M
Michael HansenNov 3, 2025
What to do if my Roughneck 57133 has low or no flow rate?
- S
  Steven MyersNov 3, 2025
  If your Roughneck Water Pump has low or no flow rate, here are some possible causes and solutions: * **Low level in the suction tank:** Refill the tank. * **Foot valve blocked:** Clean and/or replace the valve. * **Filter clogged:** Clean the filter. * **Excessive suction pressure:** Lower the pump with respect to the level. * **High loss of head in the circuit:** Use shorter tubing or tubing with a greater diameter. * **By-pass valve blocked:** Dismantle the valve, then clean and/or replace it. * **Air entering the pump or the suction tubing:** Check the seals of the connections. * **A narrowing in the suction Tubing:** Use tubing suitable for working under suction pressure. * **Low rotation speed:** Check the voltage at the pump, adjust the voltage, and/or use cables o...