Bonnet Opening
50
1. From inside the car, pull the bonnet release lever.
2. Push the safety catch lever away from the front of the bonnet
and raise the bonnet.
3. Unclip the support stay.
4. Fit the support stay into the bracket as shown.
Closing the bonnet
Raise the bonnet slightly to release the support stay, then replace
the stay in the clip. Lower the bonnet onto the catch, then use the
palms of both hands to press the bonnet fully down to engage the
catch.
WARNING!
DO NOT drive with the
bonnet retained by the
safety catch alone.
For Your Safety .........
After closing the bonnet, check
that the lock is fully engaged by
attempting to lift the front edge
of the bonnet. This should be
free from all movement.
H2162
3
4
2
1
To Next Page