Bulb Replacement
80
Fog and driving lights (if fitted)
1. Remove the screw at the base of the light. This will release the
lens and bulb assembly from the lamp body.
2. Detach both electrical connectors.
3. Unhook both sides of the retaining clip, and pivot the clip away
from the rear of the light.
4. The bulb can now be removed. When replacing a bulb, note that
shaped cut-outs in the metal base plate ensure the bulb’s
correct alignment.
Care Points .........
During use, these bulbs may
shatter if the glass has been
scratched, or contaminated
with oil or perspiration. DO
NOT touch the glass. If
handled, clean with methylated
spirits and a clean cloth.
1
3
4
2
H2138
To Next Page