4 To remove the rear section, undo the three
nuts securing the rear section to the
intermediate section at the flange joint, and
separate the joint. Recover the flange gasket.
Disengage the rubber mountings at the side
and rear, and remove the section from under
the car.
5 To remove the intermediate section, undo
the nuts securing the intermediate section to
the front and rear sections at the flange joints
and separate the joints. Recover the flange
gaskets. Disengage the side rubber
mountings and remove the section from under
the car.
6 To remove the front section, undo the nuts
securing the front section to the manifold and
intermediate section, separate the flange
joints and remove the section from under the
car. Recover the flange gaskets.
7 If necessary, the front and rear heat shields
can be removed after removing the relevant
exhaust section, then undoing the heat shield
retaining bolts.
Refitting
8 Refitting is a reversal of removal, but use
new gaskets if the originals show any sign of
deterioration. Tighten the flange retaining nuts
to the specified torque.
4A•10 Fuel and exhaust systems - single-point injection engines
1380 Rover 800 Series Remake
To Next Page
