Locks & alarm
14
2. Lock button (padlock symbol)
• press once to lock.
• press twice to ’superlock’.
3. Unlock button
• press once to unlock.
• press and hold to operate the ’Key
activated memory seats’ facility (see ’Key
activated memory seats’).
Once the security system is armed, the
following features are activated:
• The central locking system locks all the
doors and the tailgate.
• The perimetric alarm (protecting the
doors, hood and tailgate) is armed.
• If ’handset superlocking’ is activated, the
volumetric alarm is also armed (a sensor
inside the passenger compartment
monitors the interior space and activates
the alarm if an intrusion into the
passenger compartment is detected).
The volumetric sensor will enter a self-check
mode each time you turn the starter switch
off. It will remain active for 60 seconds, or
until:
1. The driver’s door is opened and closed.
2. The vehicle is locked with the handset or
key.
NOTE: If the sensor fails its self-check five
times consecutively, only the ’perimetric’
elements of the security system will be active
(doors, hood and tailgate). Any attempt to
’superlock’ with the handset will result in
’ALARM FAULT’ being displayed on the
message centre and a mislock occurring (see
’Mislock’). Seek qualified assistance to rectify
the fault.
NOTE: The handset complies with part 15 of
the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation. This applies to
both alarm receivers and handset
transmitter.
CAUTION: Any changes or modifications to
the transmitter not expressly approved by the
manufacturer could void the user’s authority
to operate the equipment.
To Next Page
Loading...
