Off-road driving
205
After wading
Drive the vehicle a short distance and apply
the footbrake to check that the brakes are fully
effective.
DO NOT rely on the parking brake alone to
hold the vehicle stationary until the
transmission and brakes have thoroughly
dried out; in the meantime, use wheel chocks
or leave the vehicle parked in gear.
Remove any protective covering from in front
of the radiator grille.
If the water was particularly muddy, remove
any blockages (mud and leaves) from the
radiator to reduce the risk of overheating.
If deep water is regularly negotiated, check all
oils for signs of water contamination;
contaminated oil can be identified through its
’milky’ appearance. In addition, check the air
filter element for water ingress, and replace if
wet.
Vehicles required to undergo frequent or deep
wading conditions will require more frequent
servicing. See ’Owner maintenance’ and
contact a Land Rover dealer for advice.
If salt water is frequently negotiated,
thoroughly wash the underbody components
and exposed body panels, with fresh water.
BIB SPOILER
The vehicle has a bib spoiler extension fitted
to the front bumper to improve air flow during
normal driving conditions. This MUST be
removed when considering serious off-road
driving.
The bib spoiler is in two parts and is attached
to the underside of the front bumper by six
spring clips and eight plastic rivets.
To remove:
Using a screwdriver, remove the inner locking
pins from the studs, then remove the studs.
Slide the spring clips off the bib spoiler, then
separate the two halves of the spoiler.
Store all parts in a suitable container pending
refitment.
To refit:
Place one half of the bib spoiler against the
underside of the front bumper, install four
studs and fit the locking pins and three spring
clips.
Engage the other half of the bib spoiler with
the first half, then fit the remaining studs and
spring clips, ensuring that the locking pins are
fitted to the studs.
To Next Page
Loading...
