Seats
35
REAR SEAT
WARNING
DO NOT adjust any part of a seat while the
vehicle is in motion.
Ensure your fingers are clear of the seat
latches when folding the rear seats.
Folding the rear seats
One, or both parts of the split rear seat, can be
either partially folded to provide a useful
horizontal surface, or fully folded to further
increase the rear loadspace.
Before folding either part of the rear seat,
ensure that the outer rear seat belts are
correctly stowed in their belt clips (see
illustration). To avoid damaging the centre
seat belt, roll the buckle neatly and stow it in
the space provided at its anchor point in the
centre of the rear seat.
To fold either part of the rear seat, press the
appropriate release button ’A’, then fold the
backrest down to position 1. To further
increase the loadspace, fold the backrest and
seat base together to position 2.
When returning the rear seat to its normal
position, ensure that the backrest is securely
latched in place before driving.
NOTE: If the seat base is not fully latched in
position, it will not be possible to raise the
backrest.
WARNING
When the seat is returned to the upright
position the latching mechanism should be
visually checked and physically tested, to
ensure that the latch is secure before
driving.
To Next Page
Loading...
