Door mirrors
53
ELECTRICALLY-OPERATED DOOR MIRRORS
1. Slide the switch left or right to select the
appropriate mirror.
2. With the starter switch turned to position
’I’ or ’II’, press the appropriate side of the
rocker switch to tilt the mirror glass
up/down/left or right.
NOTE: The mirror positions can be set in
conjunction with the driver’s seat positions
(see ’Seats’).
NOTE: Door mirrors have integral heating
elements which disperse ice or mist from the
glass. This function operates continuously
while the engine is running.
Automatic dipping for reverse gear selection
The mirror memory has a pre-stored function
which causes the mirrors to dip automatically
whenever reverse gear is selected. If
necessary the ’dipped’ mirror positions can be
altered as follows:
1. Turn the starter switch to position ’I’ or ’II’
(do not start the engine).
2. Select reverse gear.
3. Adjust either or both mirrors to the
desired positions.
4. Press the seat MEMORY STORE switch
together with either switch 1 or 2
(whichever corresponds with the driver’s
seat memory) for 2 seconds (the message
centre displays ’MIRROR DIP STORE’).
NOTE: The right-hand exterior driving mirror
is convex and objects in this mirror are closer
than they appear.
To Next Page
Loading...
