Door mirrors
54
To disable the dip function:
Turn the starter switch to position ’I’ or ’II’ (do
not start the engine) and select reverse gear.
Press and hold the seat MEMORY STORE
switch for 2 seconds, the message centre
displays ’MIRROR DIP OFF’ and a tone
sounds.
To restore the dip function:
Turn the starter switch to position ’I’ or ’II’ (do
not start the engine), and select reverse gear.
Press and hold the MEMORY STORE switch
for 2 seconds and the message centre briefly
displays the message ’MIRROR DIP ON’
(returning the mirrors to either the factory or
your own pre-set positions).
NOTE: The mirror dip function can be
individually disabled or restored for each seat
memory position (1 and 2). Select the
appropriate memory before disabling or
restoring the function.
Manual adjustment
Each door mirror assembly can be moved
through four positions.
The fully forward and rearward positions,
enable the mirror body to fold almost flat
against the side of the vehicle and are useful
for negotiating narrow openings. The two
intermediate positions, enable the mirror body
to be adjusted to suit the differing
requirements of either the passenger or
driver’s side of the vehicle - the forward
intermediate position should be used for the
driver’s side, and the rearward intermediate
position used for the passenger side.
To Next Page
Loading...
