Electric windows
69
’One-touch’ up & down
By briefly pressing and then releasing a switch
(within
1
/
2
second), a window can be opened
or closed at a single touch. Window
movement can be stopped at any time by
pressing the opposing side of the switch.
’Anti-trap’ function
The ’anti-trap’ function is a safety feature
which prevents a window from closing when
an obstruction is sensed (’WINDOW
BLOCKED’ appears in the message centre). It
is recommended that this is set at all times,
but particularly when carrying children.
NOTE: If the ’one-touch’ and ’anti-trap’
functions have not been set, an audible
warning sounds and ’WINDOW NOT SET’ is
displayed in the message centre whenever a
window is closed and also whenever the
starter switch is turned on or off.
Setting the ’one-touch’ & ’anti-trap’
functions
If the battery has been disconnected, it will be
necessary to reset the ’one-touch’ and
’anti-trap’ functions on each window, using
the following procedure:
1. FULLY open and close each window in
one continuous operation (note that as the
window is closing, an audible warning
sounds and ’WINDOW NOT SET’ is
displayed in the message centre).
2. Once the window has been fully opened
and closed, an audible warning sounds
and ’WINDOW SET’ (together with a
window identifier message) is displayed in
the message centre.
The ’one-touch’ and ’anti-trap’ functions will
now be operational.
NOTE: The ’one-touch’ up function is
available on front windows only.
To Next Page
Loading...
