- 12 -
STARTING WARM ENGINE
STOPPING INSTRUCTIONS
1. Push the ignition switch to the “START”
position
2. Move the choke lever to the“HALF OPEN”
position.
3. Hold the unit in left hand and press it against
the ground.
4. While holding the starter handle in right
hand. Gently pull the starter rope out until
you feel that the pawls hook onto the
ƪǡǤ
5. Repeat several times until the engine starts.
6. Move the choke level to the“Full Open”
position.
Ǥǡ
the idling engine to cool down.
2. Move the ignition switch to the “OFF”
ơǤ
WARNING : Move the choke lever
to the “CLOSE” position if the engine
can not be shut down by the two
ǡ
after the machine becomes cold or
contact the authorized dealer for help.
SHOULDER HARNESS
1. Wear the harness on the shoulder then
your stature until you feel comfortable with
it on.
2. Attach harness hook to a suitable suspension
point on the harness bracket according to
ƤǤ
unit gets a good balance before operating.
WARNING : Ǧ
mechanism on the harness to free
of emergency.
.
Ǥơ
which automatically removes any excess
line that is released.
SETTING THE LENGTH OF THE CUTTING LINE
1. The trimmer head releases the line without
Ǥǡƪ
tap the trimmer head on the ground while
operating the unit at high speed．
2. The cutting line should always have the max.
Ǥǡ
ƥǤ
Ǥơ
which automatically removes any excess
line that is released.
Choke
Lever
Close
Half open
Full open
To Next Page
Loading...