Rowenta DX1550 User Manual

6
EN
If you cannot determine the cause of a fault, you can contact the ROWENTA ocial, approved
after-sales service. You will nd the addresses in the attached list of after-sales services.
You can also nd advice and tips on our homepage at: www.rowenta.com
PROBLEMS POSSIBLE CAUSES SOLUTIONS
Your iron produ-
ces little to no
steam.
The water tank is empty. Fill it up.
The anti-calc valve is dirty. Clean the anti-calc valve.
Refer to “Cleaning the
anti-calc valve” section.
Your iron is clogged up with
limescale.
Clean the anti-calc valve
and steam chamber.
Refer to “Cleaning the
anti-calc valve” and
“Self-cleaning function”
sections.
Your iron has been used for
too long in the dry ironing
function.
Clean the steam
chamber. Refer to
“Self-cleaning function”
section.
The soleplate is
scratched or da-
maged.
You have placed your iron
on a metallic iron rest or
ironed over metal zips or
fastners.
Always place your iron
on its heel rest when not
in use.
Do not iron over metal
zips or fastners.
The iron steams
once the water
tank has been
lled.
The steam control dial is
notset to .
Ensure that the steam
control dial is set to .
The water tank is too full. Do not exceed the max
level for lling.
The spray does
not spray water.
The water tank is not full
enough.
Add water to the water
tank until max level.

Rowenta DX1550 Specifications

General

Brand	Rowenta
Model	DX1550
Category	Iron
Language	English