Why is there little or no steam coming from my Rowenta Pressure & Steamer?
If you're experiencing little to no steam from your Rowenta Iron, the boiler might be empty, so you should fill it. Alternatively, the boiler might not be ready yet; wait for the steam indicator light to go out before using steam.
Why does the soleplate of my Rowenta Pressure & Steamer leave brown streaks on clothing?
If the soleplate of your Rowenta Iron leaves brown streaks on clothing, it could be due to using chemical descaling agents or additives; never use these and rinse the boiler thoroughly. Another possible cause is tap water high in organic matter such as rust or iron; switch to bottled spring water or rinse the boiler more often.
How to prevent white streaks on clothing from my Rowenta Pressure & Steamer Iron's soleplate?
To prevent white streaks on clothing from your Rowenta Iron's soleplate, the boiler may have a build-up of scale and needs to be rinsed out regularly. Rinse the boiler after every 10 uses.
What to do if steam escapes from the boiler cap of my Rowenta Pressure & Steamer Iron?
If steam escapes from the boiler cap of your Rowenta Iron, it could be because the cap is screwed on incorrectly; unscrew the cap when the unit is cold and put it back on. Another reason might be that the seal on the cap is worn; check the cap regularly for signs of wear and tear to the red rubber ring, and replace it if wear is noticed.
What to do if water runs through the holes in the soleplate of my Rowenta Pressure & Steamer?
If water runs through the holes in the soleplate of your Rowenta Iron, it could be due to several reasons: * The boiler might be too full; avoid filling it with more than 33 oz. of water. * The thermostat may not be working correctly; in this case, the appliance should be sent to an authorized service center. * The iron might have been used before reaching the required temperature; wait for the temperature/steam control lights to go out before ironing. * Water may have condensed in the steam tube if the iron hasn’t been used for some time; hold the iron away from clothing and press the steam control button until steam is produced. * The steam output control dial could be set too high for the temperature set on the iron; decrease steam output while ironing at a low temperature (...
Guidance on using tap, softened, or bottled water, and avoiding impurities.
Instructions for filling the steam generator's water tank.
Steps for operating the iron, indicators, and safe power-down.
How to adjust steam output for different fabric types and ironing techniques.
Instructions for using the appliance without steam.
Method for removing wrinkles from hanging garments using steam.
Procedure for refilling the water tank during operation.
Steps for safe shutdown, cooling, and storage after use.
How to clean the iron's soleplate, including recommended products.
Procedure for rinsing the boiler to maintain performance and prevent scale.
General| Type | Pressure iron & Steamer |
|---|---|
| Steam Output | 120 g/min |
| Water Tank Capacity | 1.2 L |
| Auto Shut-off | Yes |
| Self-Cleaning | Yes |
| Anti-Calc | Yes |
| Anti-Drip | Yes |
| Soleplate Material | Stainless steel |
| Voltage | 220-240 V |
| Frequency | 50-60 Hz |
To Next Page
