6
Automatic standby function
In case of inactivity within 10 minutes, the appliance will enter standby mode and the 2 indicator lights
will turn off.
• To restart brewing, just press any button.
• To turn off, turn the power switch off (“O” position) and disconnect from the power supply.
Programming dosing memory
The appliance has an Auto-Dose feature that ensures the desired amount of drink is dispensed each time.
1. Lift the lever and insert a capsule. Then push the Lever down fully. Place a cup on the Drip Tray.
2. Dosing Espresso:
• Press the Coffee Button
ONCE and hold for 5
seconds, then release.
The appliance will start
dispensing.
• When the desired amount is
dispensed, press the Coffee
Button again to stop.
2. Dosing lungo:
• Press the Coffee Button
TWICE and hold for 5
seconds, then release.
The appliance will start
dispensing.
• When the desired amount is
dispensed, press the Coffee
Button again to stop.
2. Dosing tea:
• Press the Tea button ONCE
and hold for 5 seconds,
then release. The appliance
will start dispensing.
• When the desired amount
is dispensed, press the Tea
Button again to stop.
3. The Dosing Memory has now been programmed to dispense your chosen quantity of coffee or tea.
NOTE: Program will be saved even if the appliance is unplugged.
Automatic dose control
The Auto-dose control allows you to pre-select your dose whilst the appliance is warming up. Once the
appliance has warmed up, it will automatically dispense the selected Coffee or Tea.
1. Lift the Lever fully and insert the capsule. Then close the Lever fully. Place a cup on the Drip Tray.
2. After turned on, both Coffee and Tea buttons will flash to indicate that the appliance is warming up.
3. While warming up, press the Coffee Button once/twice for Espresso/Lungo, or press the Tea Button
once for tea. The selected button will flash and the other button will cease to illuminate.
4. After warmed up, the appliance will automatically dispense the selected beverage.
Cleaning, Care & Maintenance
Always disconnect the appliance from the power supply and let it cool down
before cleaning and maintenance.
• Use a damp cloth to clean the exterior of the appliance.
• Remove the Drip Tray and Capsule Basket assembly, then lift the Capsule Basket out of
the Drip Tray. WARNING: Drip Tray will still be hot after use. Handle with care - risk of
scalding.
• Empty and rinse the Drip Tray in the sink to remove any liquid that may have collected.
• Dispose of the used capsules in the capsule basket - check if the pods can be recycled or composted.
• Empty and rinse out the Water Tank after each session.
• Dry all parts thoroughly and re-locate into position.
DE205_UK_A5_v1_20210513.indb 6DE205_UK_A5_v1_20210513.indb 6 2021/5/13 10:592021/5/13 10:59
To Next Page
Loading...