ROXX CLUSTER S2 - Page 17

17
User
Manual
5.4 Conguration
Home Screen
After boot process the xture is ready for operation and starts in the previously enabled mode. At home screen the
following information will appear, depending on the current operating mode:
A DMX Adress
B Operating Mode (DMX Mode, Quick Light or Standalone Mode)
C Next available DMX address depending on the xtures DMX footprint
D External Data protocol (DMX / Art-Net / sACN).
E The dot indicates the active protocol
5.4.1 Set DMX Start Address (Direct Access)
At Home Screen the DMX address can be changed directly by using the up and down arrows. During this process the
DMX address starts blinking, once it´s conrmed by pressing ENTER it stops blinking.
If the DMX address will not be conrmed by ENTER within 10 seconds, the display will jump back and show the DMX
address from before and stops blinking.
5.4.2 Selecting DMX Mode*
At home screen please press ENTER to access to the main menu (level 1).
While using UP / DOWN arrows, please select the menu item “DMX Mode” and conrm
by pressing ENTER.
In the following sub-menu (level 2), you can now choose between 7 different DMX operating modes while using the
UP/Down arrows and conrm by pressing ENTER or jump back by pressing ESC.
After conrmation the display will jump back to main menu (level 1). Press ESC for homescreen, here the selected
DMX mode will be displayed.
*
Note:
For detailed information about the several DMX modes including channel assignment please see our DMX
Control chart.
.
User
Manual
64 CH
STD
Next
( 65 )
•DMX
1
B
A
C
D
E