EN
Disassembly and cleaning of components
a. Removing the screws : Remove the four mounting screws on the front of the dispenser
door and remove it.
b. b. Component Removal : Remove the handle pin, handle, plunger, plunger O-ring and
dispenser door O-ring.
c. Cleaning the tamper : Remove the tamper from the cooling tank and then remove the
tamper seal.
d. Inspection and replacement of worn parts : Place the disassembled parts in a
disinfectant solution. Check the tamper, tamper seal, O-rings and thrust sleeve. Replace
worn parts.
e. Lubrication and assembly : After cleaning, lubricate the parts with Vaseline. Install the
parts according to the disassembly procedure.
Final remarks
• Lubrication : Before installing the piston and tamper, apply Vaseline to the seal
grooves to prevent accelerated wear. Regular lubrication can significantly extend the
life of components.
Cleaning the machine housing
• Regular cleaning : To keep the machine's exterior clean, wipe it regularly with a wet towel.
• Avoid direct rinsing : Do not rinse the machine housing directly with water to avoid damaging the
internal electrical components.
To Next Page
Loading...
