9
8
HOW TO ASSEMBLE
Firmly insert the compression silicone
into the slot below the pulp spout.
The MaXtractor™ may leak if not assembled
properly.
Note |
The UltraSqueezer™ needs to be locked in
place in order to close the hopper.
Note |
MaXtractor™ will not operate if parts are
not assembled properly.
Note |
STEP 1
Top-set Assembly
STEP 2
Top-set and Base Assembly
Assemble the strainer into the rotation
wiper, then place this assembly into the
juicing bowl ensuring the red dot
●
on
the strainer is aligned with the red dot
●
on the juicing bowl.
Place the UltraSqueezer™ into the strainer.
Turn and press down on it until it clicks
into place.
Place the hopper onto the juicing bowl
aligning the red dot
●
on the hopper
with the red dot
●
on the juicing bowl.
Turn clockwise to close, aligning the red
dot
●
on the hopper with the close mark
.
Check Before
Operating
• Wash the parts before rst use.
• Ensure that the compression silicone and silicone ring are assembled properly.
1
2
3
4
5
7
Place the pulp container under the
pulp spout and place the juice
container under the juice spout as
shown in the illustration.
Place the top-set on top of the base.
Align the arrow
▼
on the hopper with
the arrow
(open) on the base then
slightly turn the top-set clockwise,
until the hopper arrow is aligned with
the arrow (close)
.
Open
Close
Detachable
Open/Close mark on the top-set.
6
For easy assembly hold the hopper
and turn clockwise as shown in the
illustration.
TIP
To Next Page
Loading...
