What to do if my Royal Sovereign RBC-1003BK Banknote Counter display shows miscount?
If your Royal Sovereign Banknote Counter is miscounting, it might be due to the hopper tension being too loose. To fix this, tighten the tension by turning the bill thickness adjuster (located on top of the machine) one notch to the left (-). Repeat bill counting, and readjust if the problem persists.
What to do if bills eject from my Royal Sovereign Banknote Counter?
If bills are being ejected from your Royal Sovereign Banknote Counter, the hopper tension might be too loose. To correct this, tighten the tension by turning the bill thickness adjuster (located on the top of the machine) one notch to the left (-). Repeat bill counting and adjust again if needed.
How to prevent my Royal Sovereign RBC-1003BK Banknote Counter from damaging bills?
If your Royal Sovereign Banknote Counter is damaging bills, it's possible that the hopper tension is too tight. To fix this, loosen the tension by turning the bill thickness adjuster (located on the top of the machine) one notch to the right (+). Repeat bill counting, and readjust if the problem continues.
Why does my Royal Sovereign RBC-1003BK stop and show EA2, EA3?
If your Royal Sovereign Banknote Counter stops and displays 'EA2' or 'EA3', it indicates that the thickness adjustment knob's position is incorrect. To resolve this, adjust the knob counterclockwise toward the '-'.
Why is my Royal Sovereign RBC-1003BK Banknote Counter running slow?
If your Royal Sovereign Banknote Counter runs slowly, the hopper tension might be too tight. To resolve this, loosen the tension by turning the bill thickness adjuster (located on the top of the machine) one notch to the right (+). Repeat bill counting and adjust if the problem continues.
What to do if Royal Sovereign RBC-1003BK Banknote Counter does not start after reaching the batch number?
If, after reaching the batch number, your Royal Sovereign Banknote Counter doesn't restart when notes are removed from the stacker, it's likely due to dust on the stacker sensor. Clean the sensor to resolve this issue.
General| Type | Banknote Counter |
|---|---|
| Hopper Capacity | 200 notes |
| Stacker Capacity | 200 notes |
| Display | LCD |
| Batching | Yes |
| Add Function | Yes |
| Counting Speed | 1000 notes/min |
| Counterfeit Detection | UV, MG |
| Power Supply | 110V |
Detects counterfeit bills using ultraviolet light, stops counting on detection.
Detects bills lacking standard magnetic components, stops counting on detection.
Measures bill width using infrared light, stops counting on odd-sized bills.
Enables cumulative totaling of all counted bills.
Counts bills in preset batches, allowing custom batch sizes.
Details on how counterfeit detection methods are activated and managed.
Explains switching between automatic and manual bill counting start.
Describes different counting modes (Type 1, 2, 3) for handling bills.
To Next Page
