To Next PageTo Next PageWhy are bills not feeding properly in my Royal Sovereign RBC-4500-CA Banknote Counter?
If bills are not feeding properly in your Royal Sovereign Banknote Counter, the tension adjustment might be too tight. Try adjusting the note thickness clockwise (toward ‘+‘).
What to do if the Royal Sovereign RBC-4500-CA Banknote Counter display shows “DOUBLE or CHAIN”?
If your Royal Sovereign Banknote Counter displays “DOUBLE or CHAIN”, it means the tension adjustment is too loose. To fix this, adjust the note thickness counterclockwise (toward ‘-‘).
What to do if Royal Sovereign RBC-4500-CA display shows “0” but is not counting bills?
If the Royal Sovereign Banknote Counter display shows “0” but isn’t counting bills, the counting sensor may not be working correctly. Try cleaning the counting sensor by blowing compressed air throughout the stacker and vane area of the unit. If the issue persists, the unit may require servicing.
How to fix main motor if it doesn't run on Royal Sovereign RBC-4500-CA?
If the main motor and/or vane motor don’t run on your Royal Sovereign Banknote Counter, the hopper plate sensor may not be working correctly. Clean out the hopper with a soft brush or compressed air to remove any dust. If the problem continues, the unit may need to be serviced.
General| Display | LCD |
|---|---|
| Counterfeit Detection | UV, MG, IR |
| Batching | Yes |
| Add Function | Yes |
| Hopper Capacity | 300 notes |
| Stacker Capacity | 200 notes |
| Power Supply | 60Hz |
Details how to switch between automatic and manual bill counting start modes.
Describes how to count bills in batches, including setting the batch quantity.
Details how to count bills by denomination and calculate total value.
Covers features for US bills, including Magnetic, UV, and Dimension detection.
Instructions for counting bills in predefined batches and setting batch numbers.
