To Next Page

To Previous Page

CHECK-UP OF SPARK PLUG

1. Remove the cap of spark plug and screw off

the spark plug using the plug wrench.

2. Clean the spark plug all around or replace it

if it is corroded or there is too much deposit

on it.

3. Regulate the gap of the spark plug to 0.6-

0.8mm. (.024 inches - .032 inches)

The spark plug of the designated type

should be used. The applicable type of

spark plug: D8RTC (Torch) or equivalent

Questions and Answers:

Need help?

Do you have a question about the RPS Viper 150 Dirt Bike and is the answer not in the manual?

RPS Viper 150 Dirt Bike Specifications

General