Need help?Do you have a question about the RS PRO LCR-6000 Series and is the answer not in the manual?
General| Brand | RS PRO |
|---|---|
| Model | LCR-6000 Series |
| Category | Measuring Instruments |
| Language | English |
Provides essential safety warnings and precautions for operating the LCR meter.
Checks to perform after receiving the instrument to ensure it is undamaged.
Specifies the temperature, humidity, and altitude conditions for operating the LCR meter.
General introduction to the LCR-6000 Series LCR meter and its applications.
Details key specifications, test functions, equivalent circuits, and ranging capabilities.
Identifies and describes the components and controls on the front panel of the LCR meter.
Identifies and describes the connectors and ports on the rear panel of the LCR meter.
Instructions for powering the device on/off and information on warm-up time for accuracy.
Explains the four-terminal measurement configuration for connecting the DUT.
Details the display page for setting measurement parameters like FUNC, RANGE, FREQ, TRIG, LEVEL, SPEED.
Describes how to perform OPEN/SHORT/SPOT correction to eliminate measurement errors.
Configuration page for List Measure feature, setting sweep parameters and limits.
Displays list measurement results and allows configuration of Trigger, Test Mode, and Range.
Allows configuration of measurement parameters like FUNC, RANGE, TRIG, BIAS, etc.
Configures the built-in comparator for sorting DUTs into bins based on parameter limits.
Displays bin sorting results and measurement outcomes for comparator functions.
Shows the counting function for DUTs sorted into each bin.
Covers date/time, account settings, key beep, baud rate, remote interface, and default settings.
Displays firmware version, serial number, and other system information.
Details operations for saving, recalling, and deleting files from internal memory or USB.
Details pin assignments for output, input, and power, including circuit diagrams.
Illustrates the timing sequence of signals for handler interface operations.
Flowchart showing the basic steps for measuring impedance of components.
Describes connecting and configuring the RS-232 interface for remote control.
Details connecting and configuring the USB interface for remote control.
Step-by-step guide for installing the necessary USB VCP drivers.
Explains command types, tree structure, abbreviations, and notation conventions.
Lists the available functional command subsystems for controlling the LCR meter.
Commands for controlling the display page and comment lines.
Commands for setting measurement function, range, and monitor parameters.
Commands for setting the oscillator frequency and related parameters.
Commands for setting output voltage/current level and source impedance.
Commands for setting integration time (ADC) and averaging rate.
Commands to retrieve measurement data from the output buffer.
Commands for configuring comparator ON/OFF, limit mode, bins, and beep settings.
Commands for setting list sweep parameters, status, and limits.
Commands for setting OPEN, SHORT, and SPOT correction functions.
Commands for enabling measurements, setting trigger mode, and delay.
Commands for setting DC BIAS switch and voltage value.
Commands for executing file operations like saving, loading, and deleting.
Command to retrieve the last error information.
Commands for handshake, error codes, key lock, and result send modes.
Standard commands like *IDN?, *TRG, *SAV, and *RCL.
Details display type, test functions, monitor parameters, measurement speed, and frequency ranges.
Provides physical dimensions of the LCR-6000 Series meter.
Explains accuracy calculation formulas for L, C, R, |Z|, D, Q, θ, and Rp.
Details how signal amplitude, frequency, and temperature affect basic accuracy.
To Next Page
