8
1 - 5 MAINSHEET BLOCK ASSEMBLY
Compress the existing spring (as removed in step 1.1) using
cable ties then shackle the ratchet block onto the eyelet.
Add the eyelet onto the ratchet base.
Make sure the plastic spring
washer goes back on the
right way up.
Once the shackle is tightened,
cut the cable ties.
Take the new ratchet base, align the three pins with the holes in
the adapter plate, then push it down then forwards to lock into
place.
1.
2.
3.
See appendix for instructions regarding tting a
swivel jammer upgrade.
To remove, release the
catch on the block base
using the tool provided.
You should hear a click as the catch engages.
To Next Page
