c)
a)
b)
• Finally, thread the end back through the eyelet on the boom, in the opposite
direction to the other end, and tie a gure-of-eight knot in the end
3.5 - Rigging the Boom
3.6 - The Daggerboard
To complete this section, you will need:
• The daggerboard
• Daggerboard retaining elastic
• Daggerboard retaining clip
• Thread one end of the daggerboard retaining elastic through the
daggerboard handle, and tie a gure of eight.
• Tie the daggerboard retaining clip on to the other end of the daggerboard retaining
elastic using a knot on a knot.
To Next Page
Loading...
