3.9 - Rigging the Jib
• Pull the rope taut, and tie it off using two or three half hitches.
k)
l)
• Tie one end of the jib halyard onto the loop of
rope sewn into the head of the jib, using a knot
on knot.
Note: Instead of a rope loop, the RS Feva Race Jib has a metal eye at the head.
Tie the jib halyard to this in the same way.
m)
• Pull the jib up and tie the halyard off
around the horn cleat on the side of the
mast. Only apply enough halyard tension
to prevent the front of the jib from
sagging whilst sailing.
To Next Page
Loading...
