Sails
1. Ensure furling drum line is completely wound onto
furling drum before you attach the jib.
2. The furling line/cleat can be found on the
starboard side of the foredeck just in front of the
jib sheet track/cleat)
h the jib tack to the
g th
s
gging or dam
sailing)
4. Fasten the head of
clevis pin and split ri
and split ring to prev
other sails and lin
t of aft
u
nsure h
gaging in mast track groove)
se
il the
is
taught.
7. Cleat and tidy away
osi
.
meas g tension do NOT exceed 24 units
75 metres above the vernier adjuster.
Jib
3. Unroll the jib and
furling drum usin
provided. (Tape up the
prevent sna
and lines during
attac
e large shackle
hackle and pin to
age to other sails
the jib to the swivel using the
ng. (Tape up the shackle, pins
t snagging or damage to
es during sailing)
en
5. Hoist jib by pulling the
face of the mast then
rchase system onto jib
ook is facing aft to
white halyard ou
hook the jib halyard p
Halyard wire. (E
prevent it en
6. Tension the jib
halyard purcha
system unt
jib luff wire
both rope ends in the
tioned on the top of
halyard pocket p
the gennaker sock
ure the riNote: If a loose gauge is used to
or 150Kg - measured on the shroud 0.
16
To Next Page
Loading...
