12. If the trapeze option is fitted: Now the rig tension
has been applied, the lower shrouds can be tuned,
they should be adjusted until both wires are equal,
JUST in tension, but not pulling the mast aft, then tied
off.
Genn
aker
1. Ensure the end of the gennaker halyard taken
from the base of the mast is free of knots and
tangles.
2. Take the gennaker halyard from the base of the
he
attached to the
n in the picture)
4. Pass the halyard across the boat and
through the pulley block at the aft end of
the gennaker sock.
5.
er extension and
carefully pass the end of the halyard up
the sock until you can grasp it from the
front end of the gennaker sock opening.
mast and pass forward, under the gennaker sock
and round the gennaker pole outhaul block. (T
gennaker pole outhaul block is
rope led from the pole as show
a
/
3. Thread the halyar
gennaker
edge of the
d aft
halyard cleat
foredeck on
nd through the
fairlead at the aft
the starboard side.
Tie the end of the halyard to something
such as a batten or till
18
To Next Page
Loading...
