3. COMMISSIONING
3.1 Preparation
Your RS Vision comes complete with all the components necessary to take
the boat sailing. In order to commission it, you will need the following tools:
• Pliers or a shackle key
• Small, flat-bladed screw driver
• Small Pozidrive screwdriver
• 10mm Spanner
• PVC electrician’s tape
Whilst your RS Vision has been carefully prepared, it is important that new
owners should check that shackles and knots are tight. This is especially
important when the boat is new, as travelling can loosen seemingly tight
fittings and knots. It is also important to check such items prior to sailing
regularly.
3.2 Unpacking
Having unpacked your RS Vision, you should check that you have all of the
items listed below before throwing away any of the packing, as there may be
some small items still wrapped.
• 1 x RS Vision hull
• 1 x mast
DO NOT use a knife or other sharp object to cut through packaging containing
parts – you may damage the contents!
To Next Page
Loading...
