41
6. MAINTENANCE
6.1 Boat Care
The RS Tera is made using Comptec PE3, a three-layer polyethylene
construction. This is stiff and light, but will dent if subjected to point loading.
The boat should be supported ashore on an approved RS trolley, as the hull
may distort if not supported properly. For long-term storage, it is better to
support the boat on a rack, in slings, or another type of support that spreads
the weight and avoids point loads. The hull can also be stored on the
transom, but never store the boat for long periods on its side. When dealing
with a marine environment, equipment gets wet; this in itself is not a problem.
The problem starts when moisture is trapped for any length of time. Therefore,
it is very important to store the boat properly ashore.
Keep your dinghy drained and well ventilated
• Ensure that the boat is stored with the bow raised to allow water to
drain away.
Wash with fresh water
Fresh water evaporates far more quickly than salt water so, if your dinghy has
been sailed in salt water, rinse it thoroughly. The fittings will also work better if
regularly washed.
Any stubborn marks on the hull can be removed with a light detergent, such
as washing up liquid. Always test cleaning products on a small, inconspicuous
part of the deck before applying to the whole boat.
To Next Page
Loading...
