RTI RHS 980 User Manual

7
FIRST TIME USE
The first time a new RHS980 is turned on it will automatically perform a routine where the language is selected. The
language can be changed later if desired in the Setup Mode.
The RHS980 will arrive without any refrigerant. It will be necessary to put new refrigerant into the internal charge
cylinder before any other sequences can be run. The amount of refrigerant which must be transferred is factory set at
18 lbs. Connect the short yellow hose on the rear of the RHS980 to a new 30 lb. cylinder of refrigerant. Open the
cylinder valve, turn the cylinder up-side-down and place it on the platform. Secure with web belt.
Plug the power cord into an appropriate power source. Avoid using an extension cord. If necessary, use a good
condition, three wire grounded, #14 AWG or larger extension cord of the shortest possible length.
R T I T E C H N O L O G I E S
R H S 9 8 0
S E L E C T L
A
N G U
A
G E
► E N G L I S H E S P
A
Ñ O L
F R
A
N
Ç
A
I S D E U T C H
▲
,
▼
W E I G H T = # # . # L B
A
U T O M
A
T I C
S T
A
RT?
W E I G H T = # # . # L B
R E C Y C L E
S T
A
RT?
W E I G H T = # # . # L B
V
A
C U U M
S T
A
RT?
W E I G H T = # # . # L B
C H
A
R G E
S T
A
RT?
W E I G H T = # # . # L B
F I L L C Y L I N D E R
S T
A
RT?
C O N N E C T H O S E S
O P E N V
A
L V E S
S T
A
RT?
Press the Power Switch to turn on the RHS980.
The screen shown to the left will be displayed and a
buzzer will sound.
Press ▲ or ▼ key to scroll the displayed arrow to the
desired language. Press START key.
The screen shown to the left will be displayed. Press
the ▼ key to scroll to the next screen.
Press ▼ key.
Press ▼ key.
Press ▼ key.
Press START key.
This is a reminder that the cylinder of new refrigerant
must be connected to the yellow hose on the rear of
the RHS980. Press START key.

RTI RHS 980 Specifications

General

Brand	RTI
Model	RHS 980
Category	Industrial Equipment
Language	English