RTW PortaMonitor - Page 44

PortaMonitorPage 7-2  Switches and menus
If the unit is set to 'SURR/LtRt' mode a repeated operation of the RTA
key toggles the input for the RTA analysis between the channels
predefined in the RTA menu or either an external supplied or internal
calculated Lt/Rt signal.
7.2.4. Status key:
The use of this pushbutton or its equivalent external function control calls
the AES/EBU status display. However if no digital signal is present or
valid the message : RECEIVER UNLOCKED! will be seen.
7.2.5. OPT1 key:
The use of this pushbutton or its equivalent external function can be
predefined in the GENERAL menu. It can either be disabled or used to
toggle between analog and digital input mode.
The key will be disabled also in mixed mode operation.
7.2.6. OPT2 key:
The use of this pushbutton or its equivalent external function can be
predefined in the GENERAL menu. It can either be disabled or used to
toggle between the routing pairs.
7.3. Key functions in mode: GONIO
7.3.1. SHIFT key:
Shift key.
7.3.2. LOUD key:
Activates or diactivates the loudness display.
7.3.3. PHOLD key:
Activates or diactivates the peakhold function.
7.3.4. MEMO key:
Calls the memory to graph the maximum level and the most negative
correlation and a numerical display for level and digital errors.
Some function may only be
possible with certain versions of
hardware.
This function requires the
RTA and surround software.