Rubicson 40440 - Using the Air Purifier

6
ENGLISH
How to use the air purier
Placement
The combination of active oxygen and negative ions create a molecular mass that’s heavier than air�
Therefore, you should place the air purier about two metres above the ground� There is no fan inside the
air purier, it is therefore more efcient when it’s placed near the room’s existing ventilation or fans� Don’t
choose a place where the air leaves the room�
Place the air purier indoors on a at surface or hang it on the wall using the two rear holes� Don’t let any
objects obstruct the air circulation�
When placing the air purier in a vehicle, make sure you prevent injuries by attaching it securely� Use, for
example, self-adhesive touch fasteners�
Two working modes
It is recommended that the air purier should be allowed to run all the time in large rooms or in rooms
where the air is heavily polluted� This mode is called “Hi”�
For smaller rooms, use the “Lo” mode� The Air Purifyer will turn on and off according to a built-in timer�
An external timer (sold separately) can be connected between the outlet and the AC adapter to control the
rhythm�
You can change the working mode at any time�
Use
1. Connect the AC adapter for indoor use, or use the 12 volt plug for use in a vehicle�
2. The Air Purifyer starts up automatically�
3. The air purier can run in two different modes�
•
Choose “Hi” for high effect�
•
Choose “Lo” for low effect�
4. Remove the power adapter from the wall socket to turn off the Air Purifyer�