Need help?Do you have a question about the Ruckus Wireless Ruckus ICX 7650 Series and is the answer not in the manual?
General| Humidity | 5% to 95% non-condensing |
|---|---|
| Model | Ruckus ICX 7650 Series |
| Uplink Ports | 100GbE, 40GbE, 25GbE |
| Power Supply | Redundant, hot-swappable power supplies |
| Fans | Hot-swappable |
| Stacking | Up to 12 switches via Multi-Chassis Trunking (MCT) |
| Management | CLI, Web, SNMP, Ruckus SmartZone |
| Dimensions (W x D x H) | 17.3 x 22.1 x 10.5 in (439 x 561 x 43 mm) |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -40°F to 158°F (-40°C to 70°C) |
| Software Defined Networking (SDN) | OpenFlow |
Discusses QoS support for Ruckus ICX stackable devices.
Details the eight QoS queues supported on Ruckus devices.
Describes user-configurable scheduler profiles for egress queues.
Explains how to assign traffic to higher priority queues.
Configuration for global DSCP and CoS re-marking.
Configuration of DSCP-based QoS.
Options for changing QoS mappings.
Explains packet scheduling and queuing methods.
PFC feature to prevent frame loss from congestion.
Steps to change the queuing method.
Steps to enable PFC globally.
Enable PFC for a single priority group.
Steps to enable PFC on an interface.
Steps to enable PFC on multiple ports.
Rate limiting using traffic policies and ACLs.
Procedure to configure ACL-based fixed rate limiting.
Procedure to configure ACL-based adaptive rate limiting.
To Next Page
