Ruckus Wireless SmartZone 100

To Next Page

Get to Know the Physical Features of the Controller

The following sections identify the physical features of the controller that are relevant to the installation and mounting

instructions that this guide provides. Before you begin the installation process, Ruckus Networks strongly recommends that you

become familiar with these physical features.

Front Panel

The following gure shows the controller’s front panel with the bezel installed. For descriptions of the numbered parts, refer to

the table below.

FIGURE 3 The front panel of the SmartZone 100 (SKU P01-S124-WW10)

TABLE 3 Front panel parts

Number Description

1 10G Ethernet link LED (see LEDs on the Front Panel on page 15)

2 10G Ethernet speed LED (see LEDs on the Front Panel on page 15)

3 Two 10GBASE-X (SFP+) ports (SKU P01-S124-WW10 only)

4 F/D (factory default) button. Press this button for at least 10 seconds to reset the controller to factory default

settings.

5 Status LED (see LEDs on the Front Panel on page 15)

6 1000BASE-T link LED (see LEDs on the Front Panel on page 15)

7 1000BASE-T status LED (see LEDs on the Front Panel on page 15 )

8 Four 1000BASE-T (RJ-45) ports

9 Console (RJ-45 serial) port. Use the supplied console cable (or any rollover cable, also known as Cisco

™

serial RJ-45

cable) to connect this port to another device.

10 Two USB ports

11 Power LED (see LEDs on the Front Panel on page 15)

12 HDD LED (see LEDs on the Front Panel on page 15)

Before You Begin

Ruckus SmartZone 100 Getting Started Guide

14 Part Number: 800-71960-001 Rev A

Other manuals for Ruckus Wireless SmartZone 100

Need help?

Do you have a question about the Ruckus Wireless SmartZone 100 and is the answer not in the manual?

General