28
5.3 Errors
Error Solutions
Bad cross section of cut Check product for required temperature
Correct process machine adjustment?
Correct grid mounted?
Sectioning blade blunt or damaged?
Grid knives blunt or damaged?
No stabilisers mounted on grid?
Product falling past the collecting
vessel.
Machine is not level (spirit level)?
Collecting vessel not positioned correctly?
Liquid splashes on to the
operator
Product behind the plunger?
Product to hot?
Pre-compacting set too high?
Can`t close tool box. Cutting blade inserted wrongly?
Grid halves put together incorrectly?
Feeding system doesn‘t operate Operating terminal is not switched on?
„Emergency Stop“ because not all safety switches are
connected?
Machine doesn’t react Shaft is not closed?
No grid installed in cutting area?
Cutting area door not closed?
Machine performance not
sufficient
Selection of the correct machine adjustment?
Process shaft filled sufficiently?
Grid can’t be removed from
cutting area
Fastening slider not removed?
Sectioning blade not facing towards the bottom?
Should an error occur, which is not mentioned here, or should it not be possible, to rectify the
problem with the solutions mentioned above, then Rühle will help – just call:
+49 7748 - 523-0.
To Next Page
