RuiDeng DPH3205 - Advanced Operations; Data Group Management; Output Control and Button Lock

4
coding potent io meter to ch oose the data group you need to view. Then the
data group you need wil l be disp layed . And then press the cod ing
potentiometer to en t er i nto stat us of ch ang ing output state. Turn coding
potentiometer to choose ON or OFF. When choose ON, the data gro up is
extrac ted and the output status remain the same. When choose OFF, the
data
gro up is extracted and the output is closed. If you want to exit choosing
the data group,
press lssrj shortly. Then press short ly L v/ t) or [M!)
to page up or page down to ot her place to ad j ust the data you need. After
data setting done, keep press ing I sET I mo re than 2s, all the data you set
are automatica lly stored into the specified data group. In the same lime ,
you can
see the group nu mber on the right of screen. Now you can p ress
I sET ] sh ortly back to the main i nter face.
Set default boot open or close output
Page up or page down to S-IN I, and then press short ly the codi ng
potentiometer to enter i nto the setting status. Set ON , default boot open;
set o
ff , de f au lt boot close.
Function description
Open or close the output:
You
can press (~) to open or close the output on any inte rface .
Lock the button to avoid wrong operation :
On the any interface, you can keep pressing coding potentiometer more
than 2s,
all b utt ons are locked. You can see the key lo ck icon on the right
of screen. If you wa nt to un l ock al l buttons , keep pressing coding
potentiometer more than 2s , all buttons are unlocked. The key un lock ic on
will be di sp layed on the right of screen.
MO - M9 ten data groups :
MO group is the boot default data group. When you ext r ac t the data group
you need, this data group will cover MO data group an d be automatically
stored on MO data group.
Extract Shortcut storage data group M 1 or M2:
On the main interface,
keep pressing I V/t I or !A ft• more than 2s, you can
extract Shortcut storage data group M 1 or M2 qu ick ly . In the same time the
cor r esponding data group number will disp layed on the right of the screen.
Extract the specified data group :
On the main interface,
keep press ing [ SET ] more than 2s , the sequence
number of data group will be disp layed on the right of the screen , you can
turn coding
potentiometer to choose data group you need. And then press
:ssrl shortly, you can extract the specified data group you need.