S2600E/P CLI Reference Guide Chapter 2 Switch Management Configuration
Commands
Examples
The example below specifies the timeout of session is 5
minutes.
Ruijie(config-line)#exec-timeout 5 output
2.2.11 speed
To set speed at which the terminal transmits packets, execute the speed speed
command in the line configuration mode. To restore the speed to its default
value, run the no speed command.
speed speed
Parameter Description
Parameter
description
speed
Transmission rate (bps) on the terminal.
For serial ports, the optional rates are
9600, 19200, 38400, 57600, and 115200
bps. The default rate is 9600 bps.
Command
mode
Global configuration mode.
Default
Configuration
The default rate is 9600.
Usage
guidelines
This command sets the speed at which the terminal
transmits packets.
Examples
The following example shows how to configure the rate of
the serial port to 57600 bps:
Ruijie(config)#
Ruijie(config)# line console 0
Ruijie(config-line)# speed 57600
Ruijie(config-line)#
2.2.12 write
To perform the read/write operation for the device configurations (startup
configuration or system configuration), execute the privileged user command
write.
write [ memory | network | terminal ]
To Next Page
Loading...