Configuration Guide Configuring Fat AP
Normally, a fat AP can provide multiple logical ESS at the same time. The fat AP broadcasts the information of ESS by
beacon packets or probe responses and help clients choose an ESS to join according to the situation.
You can configure different ESS domains on the same fat AP and enable the fat AP to announce and accept users that
have passed authentication.
Single ESS, Multiple BSS (In Case of Multi-Radio)
Figure 4 shows application of more than one radio in a single ESS. All radios support the same service set (within one
ESS), but as they belong to different BSS, the logical coverage differs.
Figure 1-4 Single ESS, Multiple BSS Network
The network of single ESS and multiple BSS is also applicable when both 802.11a and 802.11b/g are supported. Figure 4
shows two cl
ients connecting to two radios while in the same ESS but different BSS.
Protocol Specification
IEEE Std 802.11-2012
Default Configuration
Configuring WLAN
Command Function
Ruijie#config
Enters global configuration mode.
Ruijie(config)#dot11 wlan 1
Enters WLAN configuration mode.
To Next Page
Loading...
