Ruijie RG-WLAN Series

Configuration Guide Configuring Fat AP
Ruijie(config-if-Dot11radio 1/0)#response-rssi 10
Sets the received signal strength indicator (RSSI).
Ruijie(config-if-Dot11radio 1/0)#power local 20
Sets the value of power.
Ruijie(config-if-Dot11radio 1/0)# coverage-area-control
12
Sets the coverage area of wireless signals.
Ruijie(config-if-Dot11radio 1/0)#restries long 2
Sets the long retry limit.
Ruijie(config-if-Dot11radio 1/0)#restries short 6
Sets the short retry limit.
Ruijie(config-if-Dot11radio 1/0)#sta-limit 12
Sets STA limit.
Ruijie(config-if-Dot11radio 1/0)#sta-idle-time 900
Sets the STA idle time.
Ruijie(config-if-Dot11radio 1/0)#mcast_rate 130
Sets multicast rate.
Ruijie(config-if-Dot11radio 1/0)# 11bsupport enable
Enables the AP to support 802.11b.
Ruijie(config-if-Dot11radio 1/0)# 11gsupport enable
Enables the AP to support 802.11g.
Ruijie(config-if-Dot11radio 1/0)# 11nsupport enable
Enables the AP to support 802.11n.
Ruijie(config-if-Dot11radio 1/0)# rate-set 11n
mcs-mandatory 10
Sets the modulation and coding scheme (MCS) index of
10 to mandatory on the 802.11n radio.
Ruijie(config-if-Dot11radio 1/0)# rate-set 11a disable 6
Sets the rate set on 802.11a.
Ruijie(config-if-Dot11radio 1/0)# rate-set 11g mandatory
54
Sets the rate set on 802.11g.
Displaying the Configuration
Command Function
show run Shows the configuration of the fat AP.
show dot11 wireless 1/0 Shows the related wireless parameters and configuration
of the wireless LAN card.
Configuration Examples
Centralized Management of 802.11n
Networking Requirements
The 2.4 GHz (802.11g, Radio1) network operates in Channel 6. The SSID is RUIJIE-2G. Parameter configuration is
required;
The 5 GHz (802.11a, Radio2) network operates in Channel 149. The SSID is RUIJIE-5G. Parameter configuration is
required.
Networking Topology
Figure 1-5 Network Topology of Fat AP