MODEL 51240B/53540B/53640B/61240B/63540B/63640B
25
To ensure only one
control valve
regeneration or
washing in system.
Use in RO Pre-treatment, water
supply together but regeneration in
turn. Second grade ion exchange
equipment, etc.
Remote
handling
connector
Receipt signal to
make the control
rotate to next circle
It is used for on-line inspection
system, PC connection, and realize
automatically or remote controlling
valve.
A. Signal Output Connector
1). Control Solenoid Valve（Set b-01）
① Solenoid valve on outlet controls water level in brine tank. Instruction: If
system strictly require no hard water flow from outlet in regeneration
cycle( Mainly for no hard water flow out when valve is switching or valve in
backwash or brine drawing positions), a solenoid valve could be installed
on outlet, the wiring refers to Figure 3-1.
Function:
When valve in service status, if soft water tank is short of water,
solenoid valve is open to supply soft water, but if water tank has enough
water, solenoid valve us closed, so no soft water supplied.
When the valve is in backwash status, there is no signal output. So,
solenoid valve is closed, and no water flow into soft water tank.
To Next Page
Loading...
Need help?
General
