Runxin F79A-LCD - Page 2

MODEL 82602-F79A-LCD/82602B-F79B-LCD/82604-F82A-LCD/82604B-F82B-LCD
Before the valve put into use, please fill in the below content so as to
help us to refer in the future.
The Program Type Setting (Operation by professional)
When all symbols light on, press and hold and buttons for 5
seconds to enter the menu of valve model selection. Please set the
program type in accordance with the product type.
Softener System Configuration
Tank Size：Dia. mm，Height mm；
Resin Volume L；Brine Tank Capacity L；
Hardness of Raw water mmol/L；
Pressure of Inlet Water MPa；
Control Valve Model ；Number ；
The Specification of Brine Line Flow Control ；
Injector No. 。
Water Source: Ground-water□ Filtered Ground-water □Tap Water □
Other .
Parameter Set
Parameter
Unit
Factory
Default
Actual Value
Control Mode
A-01（02/03/11/12/13/21）
/
A-01
Water Treatment Capacity
（Meter Type）
m
3
10.00
Regeneration Time
/
02∶00
Interval Backwash Times
/
F-00
Rinsing Time
/
02∶00
Rinsing Frequence
/
F-00
Backwash Time
min.
10:00
Brine & Slow Rinse Time
min.
60:00
Brine Refill Time
min.
05:00
Fast Rinse Time
min.
10:00
Interval Regeneration Days
D.
30
Output Mode b-01（02）
/
b-01
 If there is no special requirement when product purchase, we choose
3# drain line flow control，and 6305 injector for the F79 standard
configuration. We choose 5# drain line flow control，and 6309 injector for
the F82 standard configuration.