Runxin RL-R150 Programming Manual

Page 7 of 12
Initial Start Up
• Connect power to the Controller and set up programming for the valve
To Set Clock
– Unlock Valve – Press Up & Down arrow together for 5 secs until you hear
a beep.
– Press the Menu Button.
– The time will be displayed Press Menu button again.
– The hour time will flash.
– Change the Hour time to correct time by pressing the up or Down button
& press Menu to save.
– The minutes will then flash.
– Change the minutes time with the up or down arrow and press menu to
confirm changes.
Set Regeneration Time
– Unlock Valve – Press Up & Down arrow together for 5 secs until you hear
a beep.
– Press the Menu Button.
– Press the Down arrow.
– Press Menu – The hour will then flash change the Hour time to desired
time by pressing the up or Down button & press Menu to save.
– The minutes will then flash.
– Change the minutes time with the up or down arrow and press menu to
confirm changes.
Regenerate on 0m³ Capacity or at Regeneration Set Time
– Unlock Valve – Press Up & Down arrow together for 5 secs until you hear
a beep.
– Press the Menu Button.
– Press down arrow twice.
– A-01 will be on the screen.
– Press Menu it will flash press Up or Down and menu to save changes.
o The setting is either A-01 or A-02
o A-01 will Regenerate at the next set time as per previous
instruction.
o A-02 will Regenerate immediately when capacity has reached 0m³.

Runxin RL-R150 Specifications

General

Brand	Runxin
Model	RL-R150
Category	Water Dispenser
Language	English