10
salt. When the level controller reaches the required height, the refilling will be stopped. The new
saturated brine will be used for next regeneration.
Brine Refill Status
※Press and turn into Fast Rinse status, starting to Fast Rinse. About 3 minutes fast rinse will
discharge the residual brine and compact the resin particle so as to reach the best softening effect.
Fast Rinse Status
※When the sample outlet water is qualified, press and finish the Fast Rinse. Then the device
turns into Service status and start running.
Service Status
Illustration: Under regeneration cycle, the softener valve will stop flowing out from the outlet and each
status will be completed automatically according to the setting time. If you want to finish one step in
advance, you can press .
※During the trial running status, check each port. There should no mineral media flow out. Check each
connection, ensure there is no leakage.
※The time of backwash, brine & slow rinse, brine refill, fast rinse, etc. could be suggested by dealer or
professional personnel.
Notice: Under normal situation, user does not need to do any operation except adding a certain amount
of salt into the brine tank.
12:30:25
Water System
In-Service
Water
Remaining: 2.56m3
Cur. F.R.: 0.85m3/h
03:25:50
Water System
Fast Rinsing…
Remaining: 5 min.
03:15:50
Water System
Brine Refilling…
Remaining: 05:30 min.:s.
To Next Page
Loading...
Need help?
General
